ZigBee® Software from LitePoint


LitePoint ZigBee® Software for low-cost, high-volume manufacturing testImage

LitePoint ZigBee® Software Package provides manufacturing test capability for ZigBee 802.15.4-based products using IQview, IQmax , or IQflex WLAN One-Box Testers. The package includes new API commands and integration of Offset Quadrature Phase Shift Keying (O-QPSK) modulation support into the LitePoint IQsignal™ Analysis Software Suite (if applicable). When installed, the ZigBee Software Package is automatically recognized by the IQview/IQflex test analysis software and the software integrates seamlessly into the test environment. The ZigBee device under test (DUT) test commands are made through the chip vendor's test control interface for fastest set-up times, while LitePoint capture-once-measure-all hardware implementation allows full Rx and Tx testing with very few signal captures for the fastest test times.

Features

Once the DUT is in test mode, the LitePoint ZigBee Software Package provides:

  • Transmit group
    • Maximum output power
    • Minimum output power
    • Out of band spurious
    • Spectral density mask
    • Symbol rate error
    • RF center frequency error
    • EVM
  • Receive group
    • Receiver sensitivity
    • Maximum input level
    • Energy Detection
  • Advanced Analysis
    • Peak power
    • Average power
    • Average no-gap power
    • Number of Symbols
    • Packet CRC check
    • Integrated Phase Noise
  • Graphical Views
    • Code domain power
    • Spectrogram
    •  Eye Diagram
    • CCDF
    • Symbol Constellation
    • Phase Error
    • I&Q baseband
    • EVM vs symbol

 Benefits

  • Faster test times
    • Full Rx and Tx testing with very few signal captures
    • Several ZigBee IC vendor example test programs included
  • Faster set-up time
    • ZigBee DUT test commands made through chip vendor’s test control interface
    • Includes recommended test sequences including device calibration

 Next Steps